Sub-Fab Equipment Cable Assemblies

Looking for sub-fab cable assemblies? IEW has been building cable assemblies and wiring harnesses for over 45 years. Semiconductor tools run in cleanroom conditions where downtime is expensive, so cable builds must be accurate and repeatable. Sub-fab abatement and support equipment needs robust cable sets that match the tool spec. Whether it is a short signal lead or a heavy 180mm² power harness, IEW has the kit and the skills to build it. Connectors are fitted to each end as specified, crimped or solder-tinned, using a broad range of terminals and housings. Every cable is fully ATE tested before it leaves site, so it is right first time, every time. IEW is approved to ISO 9001:2015 and IPC/WHMA-A-620, the recognised standard for cable and wire harness assemblies. Repeat orders are built to the same drawing and test routine, so every batch matches the last. A 3D CAD service is available to help develop the design before it goes into production. Contact IEW for a quote on your next project.