Wellhead Control Panel Cable Assemblies

For wellhead control panel cable assemblies built properly, IEW turns customer concepts into finished, tested assemblies. Oil and gas operators expect equipment to run in tough conditions with minimal downtime, and that starts with the wiring. Wellhead control panels need accurate, tested control cabling. Builds cover ribbons to 180mm² cable, simple to complex, small to large, in low to medium volumes. Every termination can be fitted with connectors, crimped or solder-tinned, from a wide range held in stock. Nothing ships untested. Each assembly goes through automatic test equipment before dispatch. IEW is approved to ISO 9001:2015 and IPC/WHMA-A-620, the recognised standard for cable and wire harness assemblies. Repeat orders are built to the same drawing and test routine, so every batch matches the last. Need the full unit? IEW can supply turnkey builds, combining metalwork, cables, looms and PCBs into a complete assembly. Send over your drawing or requirement and IEW will quote.