ATA6563 Click Board™

Product Code: MIKROE-2334

The ATA6563 Click Board™ carries the ATA6563 high-speed CAN transceiver. The click is designed to run on a 5V power supply. Use the VIO SEL jumper for selecting the 3.3V or 5V logic level. It communicates with the target microcontroller over UART interface, with additional functionality provided by the AN pin on the mikroBUS™ line. ATA6563 FEATURES The ATA6563 is a high-speed CAN transceiver that provides an interface between a controller area network (CAN) protocol controller and the physical two-wire CAN bus. The transceiver is designed for high-speed ( up to 5 Mbps ) CAN applications in the automotive industry, providing differential transmit and receive capability to (a microcontroller with) a CAN protocol controller. It offers improved electromagnetic compatibility (EMC) and electrostatic discharge (ESD) performance. The transceiver is CAN FD (Flexible data-rate) ready, meaning it has increased data rates in comparison with classic CAN. How Does The ATA6563 Click Board™ Work?

The ATA6563 Click Board™ is connected to a CAN bus via the DB9 cable, which then communicates with the network. SPECIFICATIONS Type CAN,CAN FD Applications Classical CAN and CAN FD networks in Automotive, Industrial, Aerospace, Medical and Consumer applications. On-board modules ATA6563 high-speed CAN transceiver from Microchip Key Features Optimized for CAN FD at 2 and 5 Mbps operation, maximum propagation delay: 210ns; the chip supports CAN 2.0 and CAN with flexible data rates. Interface UART Compatibility mikroBUS Click board size L (57.15 x 25.4 mm) Input Voltage 3.3V or 5V PINOUT DIAGRAM This table shows how the pinout on ATA6563 click corresponds to the pinout on the mikroBUS™ socket (the latter shown in the two middle columns). Notes Pin Pin Notes Standby select STBY 1 AN PWM 16 NC NC 2 RST INT 15 NC NC 3 CS RX 14 TX UART data receive NC 4 SCK TX 13 RX UART data transmit NC 5 MISO SCL 12 NC NC 6 MOSI SDA 11 NC Power supply +3.3V 7 3.3V 5V 10 +5V Power supply Ground GND 8 GND GND 9 GND Ground JUMPERS AND SETTINGS Designator Name Default Position Default Option Description JP1 VIO SEL Left 3V3 VIO Supply Voltage Selection 3V3/5V, left position 3V3, right position 5V JP2 MODE SEL Left ON Selection of the standby feature; default is always on, right option switches to the STB pin on the mikroBUS™ ADDITIONAL PINS Name I/O Description CANL I/O CAN lines, same as on DB9 connector CANH I/O CAN lines, same as on DB9 connector TXD I UART lines, same as on the mikroBUS™ RXD O UART lines, same as on the mikroBUS™