CAN Isolator Click Board™

Product Code: MIKROE-2627

The CAN Isolator Click Board™ provides isolated CAN communication. It carries the ADM3053 signal and power isolated CAN transceiver with an integrated isolated DC-to-DC converter, from Analog Devices. The click is designed to run on either 3.3V or 5V power supply. The CAN Isolator Click Board™ communicates with the target microcontroller over UART interface. The CAN Isolator Click Board™ carries a DB 9-pin male connector. ADM3053 FEATURES The ADM3053 is an isolated controller area network (CAN) physical layer transceiver with an integrated isolated DC-to-DC converter. The ADM3053 creates a fully isolated interface between the CAN protocol controller and the physical layer bus. It is capable of running at data rates of up to 1 Mbps. CONNECTOR FEATURES This is a standard DB 9-pin male connector. SPECIFICATIONS Type CAN,Isolators Applications CAN data buses, Industrial field networks On-board modules ADM3053 CAN transceiver, DB 9-pin connector Key Features fully isolated interface between the CAN protocol controller and the physical layer bus.

It is capable of running at data rates of up to 1 Mbps Interface UART Compatibility mikroBUS Click board size L (57.15 x 25.4 mm) Input Voltage 3.3V or 5V PINOUT DIAGRAM This table shows how the pinout of the CAN Isolator Click Board™ corresponds to the pinout on the mikroBUS™ socket (the latter shown in the two middle columns). Notes Pin Pin Notes NC 1 AN PWM 16 NC NC 2 RST INT 15 NC NC 3 CS TX 14 RXD Receiver Output Data NC 4 SCK RX 13 TXD Driver Input Data NC 5 MISO SCL 12 NC NC 6 MOSI SDA 11 NC Power supply +3.3V 7 3.3V 5V 10 +5V Power supply Ground GND 8 GND GND 9 GND Ground JUMPERS AND SETTINGS Designator Name Default Position Default Option Description JP1 VIO.SEL. Left 3V3 Power Supply Voltage Selection 3V3/5V, left position 3V3, right position 5V JP2 SLOPE SEL Left HI Slope select, default high rate, right option the slope is limited