Charger 13 Click Board™

Product Code: MIKROE-3748

Charging of the Li+ battery cell is a demanding task that requires a very accurate current and voltage monitoring and limiting. In addition, it also requires specific charging conditions, depending on the battery level (constant current mode, constant voltage mode). Li+ batteries contain flammable chemical compounds and can easily be ignited. The RT9532GQW IC closely monitors the battery voltage and current during the charging process, ensuring safe and reliable operation. The Charger 13 Click Board™ is a perfect solution for the development of multiple Li+ battery cell charging applications, offering a set of connectors, pins, and LED indicators, allowing fast and easy prototyping. How Does The Charger 13 Click Board™ Work? The Charger 13 Click Board™ is based on the RT9532GQW - fully integrated single cell Li-ion battery charger IC ideal for portable applications. The RT9532 optimizes the charging task by using a control algorithm including pre-charge mode, fast charge mode and constant voltage mode.

The input voltage range of the VIN pin can be as high as 28V. When the input voltage exceeds the OVP threshold, it will turn off the charging MOSFET to avoid overheating of the chip. Along with its small physical size, the low number of external components makes this IC ideally suitable for various applications. The 4.2V factory preset reference voltage simplifies design. The RT9532GQW IC is designed with reliability in mind: the IC prevents draining the battery below the critical level, offers prequel charging (for deeply depleted batteries), features an overvoltage protection, charging status monitoring and so on. The Charger 13 Click Board™ itself is equipped with a set of indicators used to monitor both charging process and power distribution. CHARGE LED indicates the charge-in-progress status. STATUS LED indicates power status during the charging process. On the left side of the click board is an input screw terminal with corresponding markings, where the external voltage as high as 28V can be applied. The connector on the right side is reserved for a Li-Ion battery with GND and VBAT+ markings. When connected to power source, the green STATUS LED will indicate it, while the red – CHARGING LED will indicate the charging in progress and will turn off once the battery charging is finished. The voltage range which can be used to power up the Charger 13 Click Board™, allows for it to work with both 3.3V and 5V capable MCUs. It can be selected by soldering a small SMD jumper, labeled as VCC SEL to the correct position. SPECIFICATIONS Type Battery charger Applications The Charger 13 Click Board™ is a perfect choice for development lithium-ion (Li+) cell battery charging applications. On-board modules RT9532GQW, a highly Integrated, linear battery charger from Richtek Key Features Intelligent, constant-current, constant voltage (CCCV), temperature-regulated battery charger Interface GPIO Compatibility mikroBUS Click board size M (42.9 x 25.4 mm) Input Voltage 3.3V,5V PINOUT DIAGRAM This table shows how the pinout on the Charger 13 Click Board™ corresponds to the pinout of the mikroBUS™ socket (the latter shown in the two middle columns). Notes Pin Pin Notes NC 1 AN PWM 16 EN Enable In NC 2 RST INT 15 INT Charging Interrupt Out NC 3 CS RX 14 NC NC 4 SCK TX 13 NC NC 5 MISO SCL 12 NC NC 6 MOSI SDA 11 NC Power Supply 3.3V 7 3.3V 5V 10 5V Power Supply Ground GND 8 GND GND 9 GND Ground ONBOARD SETTINGS AND INDICATORS Designator Name Default Position Default Options Description JP1 VIN SEL Left 5V Power Supply Selection Jumper INT/EXT, l