Dediprog SF600 ISP Cable for SPI Flash Programming (ISP-600-CB1-G)

Product Code: ISP-600-CB1-G

Professional 2×6 ISP Cable for SF600 Programmer The Dediprog SF600 ISP Cable (ISP-600-CB1-G) provides the essential connection between your SF600 programmer and target boards with 2×6 2.54mm ISP headers. This flat ribbon cable enables reliable in-system programming of SPI NOR flash memories directly on the PCB, eliminating the need to remove components for programming. Wiring Quick-Start Connect the cable between the SF600's 2×10 ISP header and your target board's 2×6 header. Ensure pin 1 alignment using the red stripe indicator on the ribbon cable. The cable converts the SF600's full 2×10 pin arrangement to the standard 2×6 configuration used by most target boards. ISP Cable Pin Out (2×6) Pin Signal Signal Pin 1 Vpp CS2 2 3 CS1 Vcc 4 5 MISO/DQ1 Hold/DQ3 6 7 Wp/DQ2 CLK 8 9 GND MOSI/DQ0 10 11 NC Reset 12 Signal Descriptions CS1/CS2: Chip Select lines for addressing multiple SPI devices MOSI/DQ0: Master Out Slave In data line (or Data I/O 0 in quad mode) MISO/DQ1: Master In Slave Out data line (or Data I/O 1 in quad mode) CLK: Serial clock signal for synchronising data transfers Vcc: Target voltage supply (1.8V to 5V) Hold/DQ3: Hold signal for pausing operations (or Data I/O 3 in quad mode) Wp/DQ2: Write Protect signal (or Data I/O 2 in quad mode) Cable Maintenance: With frequent connections, the ISP cable should be replaced periodically to ensure reliable contact with application board signals in production or repair environments.

Compatible Applications This cable is specifically designed for use with SF600, SF600Plus, and SF600Plus-G2 programmers when programming SPI flash devices on target boards that feature the standard 2×6 ISP header layout.