PAC1934 Click Board™

Product Code: MIKROE-2735

The PAC1934 Click Board™ carries the PAC1934 four channel DC power/energy monitor from Microchip. The click is designed to run on either 3.3V or 5V power supply. It communicates with the target microcontroller over an I2C interface. How Does The PAC1934 Click Board™ Work? There are four 4-Terminal current sense shunt resistors connected to the current sense amplifier (in the chip). Electricity is brought to shunts via screw terminals. Middle screw connector is GND which can be used for bus voltage monitoring. The PAC1934 Click Board™ enables energy monitoring with integration periods from 1 mS up to 36 hours or longer. Bus voltage, sense resistor voltage, and accumulated proportional power are stored in registers for retrieval by the system master or Embedded Controller. PAC1934 Energy Monitor Features The PAC1934 is a four channel bi-directional high-side current-sensing device with precision voltage measurement capabilities, DSP for power calculation, and a power accumulator. It measures the voltage developed across an external sense resistor (VSENSE) to represent the high-side current of a battery or voltage regulator.

The PAC1932/3/4 also measures the SENSE1+ pin voltages (VBUS). SPECIFICATIONS Type Measurements Applications Power management systems, embedded applications, servers, personal computers, etc. On-board modules PAC1934 four channel energy monitor from Microchip Key Features 1% power measurement accuracy over a wide dynamic range, alert feature on accumulator overflow and conversion complete, that could be enabled Interface I2C Compatibility mikroBUS Click board size M (42.9 x 25.4 mm) Input Voltage 3.3V or 5V PINOUT DIAGRAM This table shows how the pinout on PAC1934 click corresponds to the pinout on the mikroBUS™ socket (the latter shown in the two middle columns). Notes Pin Pin Notes NC 1 AN PWM 16 NC Reset RST 2 RST INT 15 ALE Alert pin NC 3 CS TX 14 NC NC 4 SCK RX 13 NC NC 5 MISO SCL 12 SCL I2C clock NC 6 MOSI SDA 11 SDA I2C data Power supply +3.3V 7 3.3V 5V 10 +5V Power supply Ground GND 8 GND GND 9 GND Ground JUMPERS AND SETTINGS Designator Name Default Position Default Option Description JP1 PWR.SEL. Left 3V3 Power Supply Voltage Selection 3V3/5V, left position 3V3, right position 5V JP2 ADDR.SEL. Left 20h I2C Address select - Left position 20h, Right position 3Eh LEDS, BUTTONS, SWITCHES, CONNECTORS, ETC. Designator Name Type (LED, BUTTON...) Description LD1 PWR LED Power indication LED