Riverdi Click Board™

Product Code: MIKROE-2100

The Riverdi Click Board™ is an adapter for connecting Riverdi TFT displays to a mikroBUS socket. The onboard zif20 connector allows you to interface between the target MCU and an FT8xx graphic controller on Riverdi displays. The click runs on either a 3.3V or 5V power supply. Note: The Riverdi Click Board™ comes with a flat flexible cable for the onboard ZIF20 connector. RIVERDI TFT DISPLAYS We have more than 20 Riverdi TFT displays available, in different sizes, from 7'' to 2.8'' screens. Choose from a wide variety of frames – metal mounting frames for industrial use to the white bezel for homes and offices, and many more. I2C/SPI INTERFACE Riverdi click can have either an I2C or an SPI interface. A set on onboard jumpers allows you to switch between these communication lines. SPECIFICATIONS Type Adapter, Displays, TFT Applications Interfacing Riverdi HMI displays with mikroBUS™ compatible development boards On-board modules ZIF20 connector.

FT8xx graphic controller Key Features SPI/I2C interface with selection jumpers Interface GPIO,I2C,SPI Compatibility mikroBUS Click board size S (28.6 x 25.4 mm) Input Voltage 3.3V or 5V PINOUT DIAGRAM This table shows how the pinout on the Riverdi Click Board™ corresponds to the pinout on the mikroBUS™ socket (the latter shown in the two middle columns). Notes Pin Pin Notes NC 1 AN PWM 16 NC Reset RST 2 RST INT 15 INT Interrupt Chip select CS 3 CS TX 14 NC SPI clock SCK 4 SCK RX 13 NC Master input slave output MISO 5 MISO SCL 12 SCL SCL I2C line Master output slave input MOSI 6 MOSI SDA 11 SDA SDA I2C line Power supply +3.3V 7 3.3V 5V 10 +5V Power supply Ground GND 8 GND GND 9 GND Ground JUMPERS AND SETTINGS