Temp&Hum 16 Click Board™

Product Code: MIKROE-4733

How Does The Temp&Hum 16 Click Board™ Work? The Temp&Hum 16 Click Board™ as its foundation uses the WSEN-HIDS, a 16-bit digital ultra-low-power and high-performance humidity sensor with digital output interface and embedded temperature sensor for ambient temperature measurement from Würth Elektronik. It measures relative humidity from 0 to 100% RH with an output data rate of up to 12.5Hz. The sensor is fully calibrated with no further calibration required. The initialization of the sensor can be performed by selecting the operation mode (Continuous or One-shot) and output data rate. After initializing the sensor, it is recommended to check the availability of data samples using an interrupt signal labelled RDY and routed to the INT pin on the mikroBUS™ socket. By default, after powering up, the sensor goes to power-down mode. In power-down mode, all internal blocks are turned off to minimize power consumption. After selecting one of the two operating modes, the sensor is in an active measurement state depending on the output data rate.

The Temp&Hum 16 Click Board™ provides the possibility of using both I2C and SPI interfaces with a maximum frequency of 100kHz in Standard and 400kHz in Fast mode for I2C and 8MHz for 3-wire SPI communication. 3-wire SPI shares a single data line for the data transfer, where the Master and Slave alternate their transmitter and receiver roles synchronously. The communication interface selection can be made by positioning SMD jumpers labelled COMM SEL to an appropriate position. Note that all the jumpers' positions must be on the same side, or else the Click board™ may become unresponsive. The Temp&Hum 16 Click Board™ can be operated only with a 3.3V logic voltage level. The board must perform appropriate logic voltage level conversion before use with MCUs with different logic levels. However, the Click board™ comes equipped with a library containing functions and an example code that can be used, as a reference, for further development. SPECIFICATIONS Type Temperature & humidity Applications The Temp&Hum 16 Click Board™ is an ideal solution to be used in various temperature and humidity-related applications On-board modules WSEN-HIDS (2525020210001) - MEMS-based capacitive humidity sensor with an integrated ASIC and I2C and SPI serial communication from Würth Elektronik Key Features Low power consumption, high performance, digital output interface, embedded temperature sensor for ambient temperature measurement, fully calibrated, and more. Interface I2C,SPI Compatibility mikroBUS Click board size S (28.6 x 25.4 mm) Input Voltage 3.3V PINOUT DIAGRAM This table shows how the pinout of the Temp&Hum 16 Click Board™ corresponds to the pinout on the mikroBUS™ socket (the latter shown in the two middle columns). Notes Pin Pin Notes NC 1 AN PWM 16 NC NC 2 RST INT 15 RDY Data-Ready Signal SPI Chip Select CS 3 CS RX 14 NC SPI Clock SCK 4 SCK TX 13 NC SPI Data OUT SDO 5 MISO SCL 12 SCL I2C Clock SPI Data IN SDI 6 MOSI SDA 11 SDA I2C Data Power Supply 3.3V 7 3.3V 5V 10 NC Ground GND 8 GND GND 9 GND Ground ONBOARD SETTINGS AND INDICATORS Label Name Default Description LD1 PWR - Power LED Indicator JP1-JP3 COMM SEL Right Communication Interface Selection SPI/I2C: Left position SPI, Right position I2C TEMP&HUM 16 CLICK ELECTRICAL SPECIFICATIONS Description Min Typ Max Unit Supply Voltage - 3.